|
#1
09-20-2008, 04:57 PM
Hummer Veteran
Join Date: Aug 2005
Posts: 41
Re: Hurst Handle for 5 Speed
Ok so I guess it's going to be the Handle and the shaft. Any ideas hove the handle shaft connects to the tranny before I start tearing apart the car?
I was told by a 16 year old that if I put this handle on and bolted a giant wing to roof of the car then I could get the hummer to wheel stand! 
#2
09-25-2008, 08:18 PM
Hummer Veteran
Join Date: May 2007
Posts: 227
Re: Hurst Handle for 5 Speed
From what I remember, the shaft is held on by an allen or torx screw that is low on the drivers side of the shaft. Pop the boot off and look down that side, you should see it.
__________________
2007 H3 Lux/Adv 5 speed, Gibson Extreme Duals cat-back, K&N FIPK, PCMforless tune, SAW torsion bars, Samco Shackles, Fox Racing shocks, Trail Duty Bump Stops, 35" ProComp Xterrain tires w/Tactical Rims, Gobi Stealth Rack
#3
10-01-2008, 09:02 PM
Hummer Veteran
Join Date: Feb 2006
Posts: 191
Re: Hurst Handle for 5 Speed
6pack is correct, this is on my long list list of things to do. On the driverside there is a torx set screw, the whole thing is attached at the boot/cover by a "o" ring. You can get it off but it is a little tricky putting it back. I thought I would have a new shifter shaft turned by someone and make it so I could change the shift knob. Haven't looked if anyone is making after market on this yet.
«
Previous Thread
|
Next Thread
»
Thread Tools
Search this Thread
Display Modes
Posting Rules
All times are GMT +1. The time now is 02:59 AM.
Hybrid Mode