Hummer steps are on...

[hdmlnium]

The new rockers are a smooth black finish, were as the factory rockers were slightly texured black finish. I just installed them the way that they were, they don't look that far off at all and I figured if I had them texured painted that it still would be off a little so they are fine as is in my mind.
As far as a straight forward install goes, it was..
The hardest part was taking the factory rockers off. After you take out all the pushpins out from under neath there are plastic clips that still hold the rockers on. You need to pry the rockers off by breaking the factory clips. A little nerve racking but once you do one side the second side is a piece of cake.
Good luck with your install, it really wasn't that bad at all..

Bill

Originally Posted by Boss Hoss

Looks nice, i just bought some LE steps as well and im pretty anxious to put them on. How does the trim piece match up with the factory trim that it butts up to? Was the install straight forward?

[Boss Hoss]

Im guessing you had to take your rock rails off for the install? Mine are so banged up underneath there im thinking they may not go back on without alot of convincing/hammering.

[hdmlnium]

Originally Posted by Boss Hoss

Im guessing you had to take your rock rails off for the install? Mine are so banged up underneath there im thinking they may not go back on without alot of convincing/hammering.

Nope, the rock rails stay put. You take the plastic rockers off then you slide the steps in place. Bolt them up, put the new rockers in place then attach the ends of your fender flairs and your done.. Pretty easy install..

Bill