SMA hood handles anyone have them ?

[jah5207]

mine did the same thing. I switched the sides and turned them around. I think they have a slight angle cut in them.

[fourfourto]

What way did you end up ?
a noticable ange out or not so noticable in(as in pic)

?

[fourfourto]

Jah
if you have a pic could you list it thanks 442

[jah5207]

will post a pick tomorrow during the day. swap the bars and see though. mine are flat now but when i first put them on they were like yours angled.

[Pacey]

Hey! This is my H3 in ur picture!!

I installed them exactly according to the original instructions. Came with a nice little drilling sheet. I still have it somewhere. Don't know where but I'll check tonight. If I'll find them I'll post them here.

U need any more detailed pics?

[fourfourto]

I wasnt going to drill holes they came with no hardware.
I was going to use 3m outdoor double sided tape.

If you reverse from pic the handle itself would be tilted toward the outside on a angle.
The way in pic(I found on this forum )they would be upright but a angle on the front edge ?

Pacey better pics would be gr8 to line up properly

I noticed the bottom of the handles have a trademark ,one needs to faces up and one down.
as they are the same part.
Thanks 442

[Pacey]

No Probs!
I'll shoot a couple of more detailed pics tonight and post them tmrw. As I remember it was a bit tricky at once. But then I had the drilling instructions.

Are you sure you just want to use tape for them? I mean the handles are quite heavy and with the combination of dust and rain over a short period of time I'm pretty sure you'll end up finding both of them stuck in your windscreen doing 80 on a freeway.