 |
|

09-23-2009, 11:38 AM
|
 |
Hummer Guru
|
|
Join Date: Sep 2005
Location: fort salonga ny
Posts: 3,789
|
|
Re: SMA hood handles anyone have them ?
I wasnt going to drill holes they came with no hardware.
I was going to use 3m outdoor double sided tape.
If you reverse from pic the handle itself would be tilted toward the outside on a angle.
The way in pic(I found on this forum  )they would be upright but a angle on the front edge ?
Pacey better pics would be gr8 to line up properly
I noticed the bottom of the handles have a trademark ,one needs to faces up and one down.
as they are the same part.
Thanks 442
__________________
H3 gray adventure,brushguard,hood handles,sunroof,steps,crossbows,smokers package,window/sunroof visor,Airbrushed spare tire cover,mudflaps,K&N filter,SS Hummer insert,Hummer rubber mats,cargo rubber mat + shade,12 volt airhorn,eclipse nav/dvd/rear camera/mini remote,autostart,12 volt fridge,high beam garage remote,underhood air compressor, taillight bezels ,clinometer ,trailer brake and hitch.
|

09-23-2009, 12:52 PM
|
Hummer Veteran
|
|
Join Date: Aug 2005
Posts: 33
|
|
Re: SMA hood handles anyone have them ?
No Probs!
I'll shoot a couple of more detailed pics tonight and post them tmrw. As I remember it was a bit tricky at once. But then I had the drilling instructions.
Are you sure you just want to use tape for them? I mean the handles are quite heavy and with the combination of dust and rain over a short period of time I'm pretty sure you'll end up finding both of them stuck in your windscreen doing 80 on a freeway.
|

09-23-2009, 01:53 PM
|
 |
Hummer Guru
|
|
Join Date: Sep 2005
Location: fort salonga ny
Posts: 3,789
|
|
Re: SMA hood handles anyone have them ?
I use the good double tape a 1 inch piece should do it,I have the window visors taped and the marking light covers on for 4 years and they are holding up well.
Ill stick them on then let it cure 24 hours for maximum bond and try the tug test.
I have so many chips on my windshield if it flys off  Ill get it replaced with insurance.
There was a hood handle someone had that were tape on.
Does the instructions say what way to put them ?
thanks again guys
__________________
H3 gray adventure,brushguard,hood handles,sunroof,steps,crossbows,smokers package,window/sunroof visor,Airbrushed spare tire cover,mudflaps,K&N filter,SS Hummer insert,Hummer rubber mats,cargo rubber mat + shade,12 volt airhorn,eclipse nav/dvd/rear camera/mini remote,autostart,12 volt fridge,high beam garage remote,underhood air compressor, taillight bezels ,clinometer ,trailer brake and hitch.
Last edited by fourfourto : 09-23-2009 at 02:52 PM.
Reason: add text
|

09-23-2009, 07:37 PM
|
Hummer Veteran
|
|
Join Date: Aug 2005
Posts: 33
|
|
Re: SMA hood handles anyone have them ?
Last edited by Pacey : 09-23-2009 at 08:03 PM.
|

09-23-2009, 07:52 PM
|
 |
Hummer Guru
|
|
Join Date: Sep 2005
Location: fort salonga ny
Posts: 3,789
|
|
Re: SMA hood handles anyone have them ?
Thanks Pacey 
I think thats the way it looked better i tryed by setting in place.
That leaves the lower side toward the inside.
Pics helped alot ,if its not raining when I get home ill stick  them on
 Tip the fonts above text has a paperclip you click (then click insert all)to put all pics in post so they can be seen.
__________________
H3 gray adventure,brushguard,hood handles,sunroof,steps,crossbows,smokers package,window/sunroof visor,Airbrushed spare tire cover,mudflaps,K&N filter,SS Hummer insert,Hummer rubber mats,cargo rubber mat + shade,12 volt airhorn,eclipse nav/dvd/rear camera/mini remote,autostart,12 volt fridge,high beam garage remote,underhood air compressor, taillight bezels ,clinometer ,trailer brake and hitch.
|

09-23-2009, 08:22 PM
|
Hummer Veteran
|
|
Join Date: Aug 2005
Posts: 33
|
|
Re: SMA hood handles anyone have them ?
two final pics.
If done right, the top of the handles are completely horizontal.
Good luck!

|

09-23-2009, 11:46 PM
|
 |
Hummer Guru
|
|
Join Date: Sep 2005
Location: fort salonga ny
Posts: 3,789
|
|
Re: SMA hood handles anyone have them ?
Thanks
got them on,I pulled up on them and the hood flexes so theres a good bond
Pics were gr8 thats the way I though they went but wasnt sure.
I noticed the inside is lined up straight to the loover with a small gap ,that was helpfull.
If you repaint yours rustoleum flat black(ace hardware) is a good match.
Pics

__________________
H3 gray adventure,brushguard,hood handles,sunroof,steps,crossbows,smokers package,window/sunroof visor,Airbrushed spare tire cover,mudflaps,K&N filter,SS Hummer insert,Hummer rubber mats,cargo rubber mat + shade,12 volt airhorn,eclipse nav/dvd/rear camera/mini remote,autostart,12 volt fridge,high beam garage remote,underhood air compressor, taillight bezels ,clinometer ,trailer brake and hitch.
Last edited by fourfourto : 09-23-2009 at 11:48 PM.
Reason: add text
|
Thread Tools |
Search this Thread |
|
|
Display Modes |
Hybrid Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT +1. The time now is 05:04 AM.
|