Replaced Airbags with Coils - Service Air Suspension Light stays on???

[Easy Ed]

JohnnyBoy, Here is the wallpaper on my Storm I, FYI

Attachment 51870

Originally Posted by JohnnyBoy

The "Service Air Suspension" light is off. I think that did it!
Hahah... I got the Storm aswell... there is a new version of quickpull that works on OS 5... 5.0.0.328 is the cats assss....
I'm actually upgrading to the Storm2 this week.
If your still having issues with quickpull.. go to edit permissions for quickpull and make sure everything is set to "allow" and it will work!

[pohlease]

I tried this mod to turn off my "Service air suspension" warning and it did not work. Does anyone else have any ideas? I disconnected my battery for a long time after removing the relay.

[pohlease]

Still looking for some help on this. Anyone know how to turn off the service air suspension light? Can a dealership turn it off?

[Easy Ed]

Edit: Did you remove your bags for springs ? I have been reading through your post here and am a little confused. This post says you replaced your air bags, http://www.elcovaforums.com/forums/s...t=38979&page=2 to me that means you had new air bags installed but I guess it could mean you replaced them with coil springs (sorry, I am a little slow on reading between the lines) . But, I went over to the "other" site you said that you put springs in, if that is the case, try unplugging the compressor control module in pic below, remove the relay completly under the fenderwell and disconnect the battery, the light should go out.

P.S. Nice looking truck from what I've seen at the other site.

Attachment 52305

[love dodge]

Originally Posted by Easy Ed

Edit: Did you remove your bags for springs ? I have been reading through your post here and am a little confused. This post says you replaced your air bags, http://www.elcovaforums.com/forums/s...t=38979&page=2 to me that means you had new air bags installed but I guess it could mean you replaced them with coil springs (sorry, I am a little slow on reading between the lines) . But, I went over to the "other" site you said that you put springs in, if that is the case, try unplugging the compressor control module in pic below, remove the relay completly under the fenderwell and disconnect the battery, the light should go out.

P.S. Nice looking truck from what I've seen at the other site.

Attachment 52305

I did and nothing happened

[Easy Ed]

I am out of ideas

Pulled out the relay, check
Disconnected connector completly from compressor, check
Disconnected battery for a few minutes to clear codes, check

HUMTECH, you around ? Got any other ideas that I am missing here ????

Ed

[thibble]

Have stealer with tech II reprogram to remove air suspension ?