The conversion has begun!!!

[OrangeCrush]

Originally Posted by Viet Nam Vette

What did the Motor come out off...it is used correct??

Yeah, I couldn't afford a new engine so I bought an '07 Silverado with 44K miles. It was a total.

I was trying to keep the mileage similiar to what the truck already has so used works in both ways.


Mark

[Viet Nam Vette]

Originally Posted by OrangeCrush

Yeah, I couldn't afford a new engine so I bought an '07 Silverado with 44K miles. It was a total.

I was trying to keep the mileage similiar to what the truck already has so used works in both ways.


Mark

Cool..Smart Move. Diesel's are know for their long lasting milage as long as they are serviced when due.

Lots-a electrical gack going on there in them pics. Whats the HP and Torque rating on that motor.. ?

[splne1]

LOOKING GOOD!!!

[timgco]

Damn Mark, have that rig shipped to Denver for some testing! I run that rig up I70 through the mountains and make sure that deisel works properly!

[OrangeCrush]

Originally Posted by splne1

LOOKING GOOD!!!

Thanks bud.... getting there.

Originally Posted by timgco

Damn Mark, have that rig shipped to Denver for some testing! I run that rig up I70 through the mountains and make sure that deisel works properly!

I'll make ya a deal. I'll ship it from CA to CO and you drive it to me when you're done, deal?

[kalantar]

Any updates?

[OrangeCrush]

Originally Posted by kalantar

Any updates?

Yup, sorry, should have kept this going...

Engine and all drivetrain is in and done. Body's on.... (he had to take it off roughly 5 different times to make sure everything fit... and then when he did get it on, he found out he had to pull the body one more time and make new engine mounts, tranny mounts and shorten the driveshaft (again)

He had it in there but felt it would be better if it was one more inch back so he redid it all.

Anyway, he's doing the electrical this week, then he sends it to his buddy who works at a Hummer dealership to make sure all electrical systems function correctly.

Oh, the only other thing is the radiator support. Because you have to basically cut it out and drop it down a few inches, the upper tie bar gets cut to crap.

So he made his own upper tie bar out of stainless and sent it out to get laser cut.

Other than that, shipping will add another 3-4 weeks on to this.

Almost done...


Mark

[HummerJim]

As you know the trick is in all the details (take it from one who dropped a small block Chevy into an XKE when he was in his 20s)! Even with a custom oil pan the steering and front end suspension required some hair pulling. Never could fit the heater blower, so it ended up under the dash with a small Crosley unit and it took 4 months to track down a short that was draining the battery. From the pictures, it looks like your guy really has his sh** together.
It looks like he is doing a very thorough job. 3 - 4 weeks for shipping? You're not going to drive it cross country, make a vacation out of it, visit your Hummer friends on I70??? With the old one being Orange Crush, this one should be the Beast! You are going to have so much fun in that Hummer!