|
#1
08-29-2010, 07:18 AM
Hummer Novice
Join Date: Feb 2009
Location: Southern Indiana
Posts: 21
Re: Two Questions About SUT Bed
If you just need to clean them out, take a flat blade screwdriver and remove the covers (#29 in blow up). They are each held in by 4 tension prongs. Just pop 'em out. Then take your screwdriver and a pair of needlenose pliers to dig out the hard to remove stuff. Finish with a blast of water...
You can also just clean them out from below the truck with your finger, but they are easier from the top.
__________________
2007 Hummer H2 Yellow SUV
37"x13.5"x20" Toyo Open Country MT's, 20x10 Method Racing 301's, Fox 2.0 Performance Series Shocks, Truxx Level kit, color matched grill, (Almost) all chrome removed, Removeable U-steps, Factory All weather mats, Gobi flip-up front plate, Factory brush guard
#2
08-30-2010, 03:42 AM
Hummer Professional
Join Date: Nov 2009
Location: Windermere, FL
Posts: 297
Re: Two Questions About SUT Bed
I got the trays out and cleaned them.
The reason I was asking about the "floor" was because I noticed there's a small gap where acorns and such could get under it, and I wanted to take it off and clean it.
__________________
White 2005 SUT, Lifted 7.5" via Fabtech/custom work, Fabtech Dirt Logic 2.25 shocks, 40x15.5x22 Toyo's, black 22" Fuel wheels, 4.88 gears, Dynatech long tube headers, Magnaflow exhaust, Air-raid intake, Superchips programmer, Edlebrock panhard bar, Cognito UCA's, Kryptonite tie rods, Cognito pitman/idlar arm gussets, Hotchkis swaybars and trailing arms, Amp Research steps, E&G fender flares, PIAA SMR's, smoked roof lights (bulbs removed), black suede headliner, 13" JL's under seat
«
Previous Thread
|
Next Thread
»
Thread Tools
Search this Thread
Display Modes
Posting Rules
All times are GMT +1. The time now is 08:56 AM.
Hybrid Mode