another p0300 question

[HUMTECH]

If you had a scanner with live data you could swap ign coil, plug and wire with other cylinders to see if the misfire follows any of those parts.

[HMH2SUT]

thanks tech ill check that out tomorrow see what happens. i had heard that number 7 is a collection point... is it possible number 2 has the same issue? they are at opposite corners i believe if im not completely brain dead.

[HUMTECH]

#2 is likely just showing misfire counts cause it follows 7 in the firing order. would concentate on 7 and see if that fixes it first. Especially cause it is showing fewer misfire counts

[HMH2SUT]

knock on wood! the problem seems to be solved... i pulled both fuel rails today, i found noticable dirt in the number 2 side. I found even more dirt grit on the number seven side, but no signs of water. cleaned everything up nice, i replaced the number 7 injector to be safe. Sucked what i could from gas tank, refilled it. cleared the codes and it fired right up nice and smooth. i drove if for about 20 miles no problems. hopefully that was the issue and the light will stay off.

Thanks for the replys tech and everyone, they are greatly appreciated