Exhaust Gasket leak and stud broke

[fllaw1]

Originally Posted by Easy Ed

I replaced all of mine (both sides) and it is not really bad job, just takes some time and some "grin and bare it" too when parts are in the way of getting another part removed. Examples, had to remove a O2 sensor to get to a manifold to exhaust pipe nut removed. Then I had to un-hook front drive shaft to get to another manifold to pipe nut loose. Just a bunch of small things to make the day go by before ya know it

I had all kinds of 1/2" extensions, rachets, sockets, knuckles, vise grips and so on and was able to get it done in a afternoon and evening and not had a problem since, the new manifold bolts are of a different design and should last longer, larger head and a bigger radius under the head causing less of a fracture point.

Part way down this page you can see all the parts http://www.elcovaforums.com/forums/s...ad.php?t=38098

Oh yeah, $2500.00 is too much in my book

Ed

ED, I am thinking of doing the same thing you did and replace everything to my 03 it has 23k miles on it and the bolts look a little rusty from the exterior. What do you recommend to remove them with out breaking them off, I was thinking of hosing them down with Penetrating oil before I do it.

[Easy Ed]

Except for the broken ones, mine came loose without adding anything to them. The broken ones came out using a pair of vise grips. If you want to play it safe go ahead with the penetrating oil on the 12 manifold to head bolts and to the 6 manifold to pipe nuts.

The part number for the bolt is 11518860 and the stealership got me for $1.76 each in 2009 ($21.12 for the 12 of them). For gaskets, I bought them at NAPA and they were, FPG MS92467 for the manifold to head gaskets, the set of 2 was $13.29, FPG 61323 for the manifold to pipe gaskets they were $5.49 each.

Good luck, Ed

P.S. 23,000 miles, mine is at around 90,000 now.

Originally Posted by fllaw1

ED, I am thinking of doing the same thing you did and replace everything to my 03 it has 23k miles on it and the bolts look a little rusty from the exterior. What do you recommend to remove them with out breaking them off, I was thinking of hosing them down with Penetrating oil before I do it.

[AndyMac]

Originally Posted by Easy Ed

The part number for the bolt is 11518860 and the stealership got me for $1.76 each in 2009 ($21.12 for the 12 of them).

Wow, they want to gouge me 10 bucks a pop for the bolts up here in the great white north. Think I may have to run state side for the bolts!