Does anyone buy used ring and pinions?

[tyler1bo]

Yes I was not calling Mark sketchy Mark I'll PM you to see what you'd want for them. And to add to the thread, I kinda thought myself that 5.38's would be too much. You have a ton of power going to the wheels anyways, I don't think I would go past 4.88-5:13 at the most. Just my two cents though!

[OrangeCrush]

Originally Posted by tyler1bo

Yes I was not calling Mark sketchy Mark I'll PM you to see what you'd want for them. And to add to the thread, I kinda thought myself that 5.38's would be too much. You have a ton of power going to the wheels anyways, I don't think I would go past 4.88-5:13 at the most. Just my two cents though!

I agree, 5.38?s would probably be a bit too much.... I?m thinking 5.13?s might be better... I hadn?t really given it that much thought yet.


PM responded to.


Mark

[twr]

Hi my mistake but when you have been on the forum awhile you stick up for guys that are all good. Also 513 are a hell of alot of gear with 700 to 900 FPT.

[tyler1bo]

haha. I understand man I'd do the same.

[twr]

Originally Posted by tyler1bo

haha. I understand man I'd do the same.

Thanks, i misunderstood

[tyler1bo]

No biggie!

[HUMTECH]

Tough thing about using a used gear set is it needs to have the same contact pattern(set up) as it was originally run. The further away you get from the original setup the more gear howl you could potentially get. Sometimes they work out, sometimes not