Remote Start Problems?

[Flare]

FYI - you'll have to reprogram both remotes at the same time.

(from the 2008 owner's manual)
1. Press the vehicle information button (second one on the DIC) until
PRESS V (check mark) TO RELEARN REMOTE KEY displays.
2. Press the set/reset button until REMOTE KEY
LEARNING ACTIVE is displayed.
3. Press and hold the lock and unlock buttons
on the first transmitter at the same time for
about 15 seconds.
On vehicles with memory recall seats, the
first transmitter learned will match driver 1
and the second will match driver 2.
A chime will sound indicating that the
transmitter is matched.
4. To match additional transmitters at this time,
repeat Step 3.
Each vehicle can have a maximum of
eight transmitters matched to it.
5. To exit the programming mode, you must
cycle the key to LOCK/OFF.

Hope this helps.

[tyler1bo]

I'll try reprogramming it, that may be the issue. Btw, post some pics of this jewel you're ridin it. Looks like a good mod list so far!

[Flare]

Good luck and will do on the pics. I'm out of town so it'll have to wait until I get back. I did review your machine on some other threads - very nice, awesome professional pics!

[tyler1bo]

haha thanks man! Glad you think they're professional! They're just me being bored.

[HUMTECH]

If you have any trouble codes set in the ecm it will disable the remote start function, lights will flash but will not start. Scan for codes, clear them and try again

[tyler1bo]

That was it! I've had a PO449 code the past few days, this morning I started the truck and the check engine light never came on. Idk why, it's been on for awhile now. But I just went outside and used my key fob and it started right up. It's weird :/

[HUMTECH]

Cool, glad i could help