Wiring diagram or info for liscense plate remote location

[HUMTECH]

License Plate Light Wiring Instructions

1. In front of rear bumper underneath vehicle on driver side, locate cluster of three plugs. The white
plug housing should have no existing wiring.
2. Remove the white plug housing from receptacle by pushing in the tab and pulling down.
3. Remove the wire retainer from the plug housing.
4. Remove the two orange plugs as shown in drawing.
5. Push terminal ends for tag light into plug as shown in drawing.
6. Replace wire retainer.
7. Route plug housing and wire back to receptacle and plug in firmly to engage tabs.
8. Use provided wire ties to secure excess wire.

Photo below shows finished installation.

9. Install license plate

10. Turn vehicle lights on, check to see that license plate light functions

[iwillnc]

As always many thanks Humtech, these are for the after market reposistion I assume?

[HUMTECH]

Diagram is the factory wiring the truck came with. Instructions below are the ones we would get with the SMA tire carrier kit. For some reason it would not let me copy and paste the pictures. Google hummer sma tire carrier and you should be able to find what ya need

[iwillnc]

let me rephrase it's not an aftermarket tire carrier but rather the dealer installed one, it was sold new with it in 2003

[HUMTECH]

In 2003 the only tire carrier was the sma one. I installed many of them prior to delivery. At the time GM didnt offer an outside spare tire carrier.

[HUMTECH]

Is this what yours looks like?

[iwillnc]

Oh I see, yes it does, and I did look online I could find any diagrams or wiring templates or the such.