Ignition Switch & dead battery fix

[Contract_Pilot]

HumTech

I Swapped the Ignition Switch, Swapped relays, Removed Cowl (PITA), Un Plugged Wiper Motor, No Go, Un Plugged wiper module what would you know same as taking the fuse out. Well I think i have a bad Wiper Module any other place I should look, I did have some corroded and bad solder connections I touched them up and still not go odd thing is my wipers work just fine.

And part number for wiper control Wiper/Washer Module

I pull the washer Relay and I get wipers but not interment and the thing works like it should..

I came up with part number 19120103

Part on order and will update....

[Contract_Pilot]

Originally Posted by Contract_Pilot

HumTech

I Swapped the Ignition Switch, Swapped relays, Removed Cowl (PITA), Un Plugged Wiper Motor, No Go, Un Plugged wiper module what would you know same as taking the fuse out. Well I think i have a bad Wiper Module any other place I should look, I did have some corroded and bad solder connections I touched them up and still not go odd thing is my wipers work just fine.

And part number for wiper control Wiper/Washer Module

I pull the washer Relay and I get wipers but not interment and the thing works like it should..

I came up with part number 19120103

Part on order and will update....

Update 04/26 got the part will update later today once I get it installed.. Installed, Washer Relay back in and working as it should..

[HUMTECH]

So its fixed? Wiper module?

[Contract_Pilot]

Originally Posted by HUMTECH

So its fixed? Wiper module?

Yes, It was the Wiper module! But I ended up breaking 2 clips on the cowling there were rusted out. Need to find the replacement part numbers order a set of 4 the other 2 dont seem to be gripping as they should either.

[Easy Ed]

Bought my clips here http://www.clipsandfasteners.com/GM_...r_p/a20860.htm

Ended up with more than needed but at the time I could not find them any where. Might use part number to see if you can get them cheaper.

I had a wiper module problem (ran all the fluid out of the tank to the rear wiper) and found that there was condensation in the module, dried it out and was go to go and been good since. Then they put out a recall on the 2003 models for the module. here is a post on that http://www.elcovaforums.com/forums/s...ad.php?t=35772

Congrats on fixing yours,

Ed