Ye olde "key stuck in ignition" issue

[orlasttoy]

yeah it's really hard to tell. i tried pulling on it, but didnt wanna screw it up more.

the blue pin popped out easily, but thats as far as i got.

I was able to solder onto a tiny piece of exposed wire, but it's def gonna break again.

gotta get that wire out so i can solder further away from the clip to minimize movement

[orlasttoy]

anyone know where i can get another clip or a part # so i can have a backup plan?

thanks!

[guruerror]

Originally Posted by orlasttoy

anyone know where i can get another clip or a part # so i can have a backup plan?

thanks!

You can look for a part# here: http://parts.nalleygmc.com/

But you'll prolly only find the whole harness...BUT check the Product Fitment/Applications section for other vehicles that it may have been used on; then go to the junkyard with a pair of wire-cutters. Snip snip and you gotta clip.

Also check the Fitment for the module that the cable plugs into. The cable itself may be model-specific due to the unique dimensions of the deuce, but the device it connects to will probably be a standard crossfit part...since you're only looking for the end connectors you should be golden 'cause those will be the same.

[orlasttoy]

Awesome...thank you.

[LoJac963]

Typically the pins are a small metal pin that has barb on it. If you have something like a dental pick to push through the front on the side of the pin with the barb you can push the barb down and release the pin.

I've taken many plugs apart on my rig for wiring up other things.

Good luck.