LoJac963's Deuce Build

[LoJac963]

Start buying those mods!!! I'll even help you install

[fyr145]

I would need a "laundry list" of each type of LED bulb and amounts so I could have it all in one box then start on one side of the rig and work my way around.

That would be a nice project to do.

(I just discovered a tiny exhaust leak on the passenger side so I thought since I have to take apart the exhaust anyway for new gaskets, I was thinking about putting shorty headers on to replace the stock manifold.)

[LoJac963]

Originally Posted by fyr145

I would need a "laundry list" of each type of LED bulb and amounts so I could have it all in one box then start on one side of the rig and work my way around.

That would be a nice project to do.

(I just discovered a tiny exhaust leak on the passenger side so I thought since I have to take apart the exhaust anyway for new gaskets, I was thinking about putting shorty headers on to replace the stock manifold.)

I would agree with shorties or LT's. I'm kind of looking forward to a leak so I have an excuse for some LT's lol!

[LoJac963]

Finally finished up an ongoing project to add a switch panel with OTRATTW switches.

I used Bondo Glass to do the bulk of the filling, looked like absolute hell. This was my first time ever taking on a project like this.

After Bondo Glass:



Cleaned up:



After Bondo Glazing and Spot Putty to refine the big imperfections:



All painted up:



Pic of the switches almost wired up completely:



Few pics installed:





Glad it is complete. I jumped the ground wires as the instructions say you can. I also jumped both the positive terminals but the top LED's stay on all the time which is odd since the source is a 12 volt ignition.....something I'm going to play around with.

The 3 right switches are fillers but fully wired with signal wires running to the engine compartment. Basically when I add more mods I'll just order a new switch face and its good to go.