For those who have IPCW front turn signals...

[LoJac963]

For some reason the tails blink opposite of the lower bumper lights. I almost like it as it draws attention that my brakes are one since people in AZ love to rear end you.



The tails are insanely bright though, they light up street signs when the brakes are on about an 1/8th of a mile away if not more. I love them.

[RJ3607]

Thanks for the video! Did you have to install load resistors for the front LED's?

Also, the blinking on your rears may be due to backwards wiring. Im just taking a guess here, but that could be it.

[LoJac963]

Originally Posted by RJ3607

Thanks for the video! Did you have to install load resistors for the front LED's?

Also, the blinking on your rears may be due to backwards wiring. Im just taking a guess here, but that could be it.

No load resistors, I was surprised I wouldn't need either resistors or an LED flasher relay when I installed both the front and rear LEDs.

I have gone through the wiring like a mad man. Testing circuits, tracing wiring, etc to try and find the reason why they do that and I'm stumped. It is something to do with the board within the tail light. I've even tried jumping different contacts from the bulb sockets to the tail lights. Then I can get them to somewhat work correctly but all the functions arent' there. It is highly annoying.

[RJ3607]

Originally Posted by LoJac963

No load resistors, I was surprised I wouldn't need either resistors or an LED flasher relay when I installed both the front and rear LEDs.

I have gone through the wiring like a mad man. Testing circuits, tracing wiring, etc to try and find the reason why they do that and I'm stumped. It is something to do with the board within the tail light. I've even tried jumping different contacts from the bulb sockets to the tail lights. Then I can get them to somewhat work correctly but all the functions arent' there. It is highly annoying.

Surprising that no resistors are needed. They must have them built in!

I would probably look at the bumper bulb and see if it had 3 different wires, and cut the turn signal wire. This way, it still comes on with the parking lights, but doesn't blink while turning. Im a bit anal though!

[LoJac963]

The tails do come with "resistor boxes" but they say not to install them for my year. I didn't install them and my flasher indicators in my cluster would stay dimly lit which annoyed the living hell out of me. I popped the resistor boxes in and it took that away.

I had thought about doing that, having only the bumper lights as brake lights but my OCD wouldn't allow me to do that lol. I would love to figure out why they blink in unison with the side markers (opposite of the lower bumper lights) and try to fix them but I'd probably end up destroying the lights in the process.