blinking side marker

[Lucky1]

I cut my old side marker apart and never finished the job. I bought several high quality leds from radio shack and then bought a new side marker .I need to complete the project.

[jrs2005]

ok cut it open, swapped LED's , not working. Used all electronics cat#led-912, ref 1726889. any ideas? 12 volts to the leds verified. Wrong LEDS? They are soldered in per the schematic on the board.
Thanks

[jrs2005]

Just in case anyone reads this, all of my replacement red leds from allelectronics.com were bad. I put in 2 amber leds, they work fine. This is an 80 cent repair for the side markers! Just need to find a good supplier of the red leds.

[LoJac963]

There is an ebay seller where I bought all of my interior LED's when I fitted them to every light in the dash, doors, and center stack. Each type of LED is heat sealed in their own bags and labeled. Never had a problem with them. I'll see if I can track the sellers name down.

[jrs2005]

Sounds good thanks. Turns out mine are ok just reversed anode and cathode. So need to solder the reds in opposite the circuit board imprint. Dremmel works well to cut the reflector open. 80 cents !