Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H2 Discussion Forums > Technical Discussion and Customizing your H2

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 04-07-2006, 02:41 AM
HUMTECH's Avatar
HUMTECH HUMTECH is offline
Hummer Authority
 
Join Date: Sep 2003
Location: Canada
Posts: 1,251
HUMTECH is an unknown quantity at this point
Default

Remove your tps sensor connector and dry it out, if that doesn't fix it after you let it run for awhile disconnect battery for 10 min, restart and let run for 15-20min should take care of it. TPS is on the throttle body and monitors throttle position. Or refer to bulletin
Subject: Reduced Engine Power - DTCs P0120 , P0220 , P1516 and/or P1518 - 03 Model Year Full Size Trucks and Utilities with 4.8 , 5.3 or 6.0 Engines - kw CEL light low LQ4 LQ9 LR4 MIL reducedpwrmde #PIP3042A - (08/30/2004)



Models: .



--------------------------------------------------------------------------------

The following diagnosis might be helpful if the vehicle exhibits the symptom described in the PI.

Condition/Concern:
Service Engine Soon Light and / or Reduced Engine Power Mode due to any of the following DTCs: P0120, P0220, P1516 and/or P1518.

Recommendation/Instructions:
If the SI diagnosis and bulletin 03-06-04-032 did not isolate a concern, the following information may help:.

Inspect the Yellow TAC Motor Control Circuit (581) about 1 inch to 4 inches from the throttle body connector to see if it is broken inside of the insulation.
Inspect S102 if there is a P1518 stored. S102 is in the engine harness and is 5.5 inches from the MAP Sensor.
Install that latest engine diagnostic calibrations in the PCM. Some 2003 model year vehicles have updated engine diagnostic calibrations available to address DTCs P0120, P0220, P1516 and or P1518. The title of the updated engine diagnostic calibration in TIS2000 is "New calibration to eliminate setting of P0120, P0220, or P1516 with the engine not running. Includes diagnostic enhancements for P1518."
If the above did not help, replace the throttle body and retorque it to 45 lb/in on the 1st pass and 89 lb/in on the second and final pass.

.

Please follow this diagnosis process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed. If these steps do not resolve the condition, please contact GM TAC for further diagnostic assistance.

Models:
(03 Cadillac Escalade) and (03 Chevrolet Avalanche) and (03 Chevrolet Silverado)and (03 Chevrolet Suburban) and (03 Chevrolet Tahoe) and (03 GMC Sierra) and (03 GMC Yukon) and (03 Hummer H2)

.



GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.
__________________
1987 Jeep YJ 403hp sbc 653hp on NOS
1998 Chev Z71
2007 Chev Trailblazer SS
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:59 AM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.