Signal for sub amp...

[genob]

Originally Posted by audiofetish

You can just just tap into the Bose sub wires. If you do this there is no need to run a crossover. If you use the rear speakers you will need to purchase a crossover, unless your amp has one built in.

ok so i take it the rear speakers are getting the full signal from the bose amp. most mono sub amps these days have built in crossovers (or adjustable low pass filters).

it's just much easier to pull those rear panels off and solder to the speaker wires and run them to a line level converter then to the sub amp.

[audiofetish]

Originally Posted by genob

ok so i take it the rear speakers are getting the full signal from the bose amp. most mono sub amps these days have built in crossovers (or adjustable low pass filters).

it's just much easier to pull those rear panels off and solder to the speaker wires and run them to a line level converter then to the sub amp.

I agree...........