MSD ignition unit

[Michael Baker]

Taz:
Simultaneously with the MSD ignition coils I also purchased the MSD 8.5mm superconductor spark plug wires (MSD 32829). Unfortunately (as in another thread on this same site), once installed the boots are too close to the headers, and started to show signs of melting. So I had to replace them again with the standard wires until I find a solution for this problem.

When I got the PO353 code I swapped out the 3rd coil for the original one, and still got the same PO353 code - that's what I meant. The car works fine for some 5-10 mins, but then starts to miss.

[Michael Baker]

Update:

MSD technical support asked me for the model numbers of the original coils on my H2 (12558693 H6T55171ZC). It seems that they then went out and bought one, and have now determined that they do NOT have a coil compatible with the ones on my H2. They say thay MAY have one in the future.

So I now have to get a refund......

Anyone else interested in these coils should call MSD support with the serial numbers of their current coils to check compatibility.

[IRA51]

It's a good thing I'm a cheapskate and didn't get those coils ,the price was the only thing that stoped me . try the heat sleeves on the wires or use header wrap and no more burnt wires .or if you realy want to do it right send your headers to JET HOT Coatings or buy a set of cermic coated headers .your engine compartment will be alot cooler too.

[Alt-F4]

Thanks for the update Michael.