Light Bar ON with Brites??

[HumminNBoatin']

Originally Posted by audiofetish

Here is a pic..... The circled wire goes to the brights...

Audio,

Thanks man I will try that, I am guessing that I tie the circled wire in at the fuse panel to the fuse that powers the high beams?

Thanks,
Eric

[audiofetish]

Originally Posted by HumminNBoatin'

Audio,

Thanks man I will try that, I am guessing that I tie the circled wire in at the fuse panel to the fuse that powers the high beams?

Thanks,
Eric

The directions for lightforce say to tap into the actual highbeam wire. I don't know which would be easier. Good luck... Let me know how it goes...

[Mr D]

I put a relay in so when I tap my horn it flashes my brites.

[HumminNBoatin']

Tomp,

I tried using your diagram as a guideline but I have two relays and the swith on my dash has 3 wires. White---Hot, Black---Gound and Blue---????? I hooked the "Blue---???" wire to a 12v live source and I hear it tripping a relay but nothing happens. Have any ideas?

Thanks,

[tomp]

Originally Posted by HumminNBoatin'

Tomp,

I tried using your diagram as a guideline but I have two relays and the swith on my dash has 3 wires. White---Hot, Black---Gound and Blue---????? I hooked the "Blue---???" wire to a 12v live source and I hear it tripping a relay but nothing happens. Have any ideas?

Thanks,

I didnt supply a diagram...

Were these lights working prior to stating this project?

[HumminNBoatin']

They still work just fine. But I cannot get them to work with the brites.