Oil Pressure Gauge Pegged to 80

[IRA51]

Oil sending unit at back right side of engine ,just behind the intake manifold

[pdxrealtor]

Thanks I'll check it out.

[Agentorange]

Its definitely the Oil Pressure Sensor. Had the same issue a few months ago on my 06 H2. Took about 30 minutes.

Its located on the top side if the back of the engine, between the firewall and the back of the intake manifold. Get a flashlight and you'll see it.

Use a 3/8" Drive 1-1/16" Deep well socket and a 6" extension. You have to move a few things out of the way to get to it but its definitely doable.

Here is a post with a picture of its location:
http://www.elcovaforums.com/forums/s...ad.php?t=41626

[pdxrealtor]

Thanks so much for this post. I was just up there today trying to do a quick locate. Figured it was on the back side out reach at the time I was messing with it. I was going to double check the connection real quick.

Was your sensor actually bad or??

[Agentorange]

Yes it was definitely bad. Just to be sure, I removed and re-installed the connector before I swapped it out and sure enough, it was still pegged at 80. The connector was a bit of a bear to pop off because of the tight location. Just go to your local AP store and pick up a new sensor.

[pdxrealtor]

Sweet. Thx again for the info. Will do...